Omron LD-105CT User Manual page 176

10.9 Replacing Non-Periodic Parts
8. Remove the drive assembly from the platform.
The motor cable to the LD Platform core will still be attached.
9. Disconnect the motor cable at the drive assembly.
Installation
1. Lift the new drive wheel up, compressing its springs, enough so that you can insert a 6
x 10 mm (0.24 x 0.4 inch) pin into the hole on the rear side of the assembly (there is a
hole on each side). This will keep the springs compressed (the wheel will be in the up
position), and make installation easier. If you saved a wheel pin when you uncrated the
platform, you can use that. An M5 x 10 screw also works well for this. See Lift the drive
wheel up, compressing its springs, enough so that you can insert a Ø6 x 10 mm (0.24 x
0.4 inch) pin into the hole on the rear side of the assembly (there is a hole on each side).
This will keep the springs compressed (the wheel will be in the up position), and make
removal easier. An M5 x 10 screw works well for this. If you saved the wheel pin, it
should be used for this. See Figure 3-9. See also on page 175.
176
Figure 10-21. Mounting Studs and Nuts at top of Drive Assembly
Figure 10-22. Mounting Screws at Bottom-Right of Drive Assembly
LD Cart Transporter User's Manual 14766-000 Rev H