Omron LD-105CT User Manual page 181

4. Loosen the outer brake-adjust jam nut at the actuator bar for the caster you are repla-
cing.
See Figure 10-26.
Lift the cable and brake-adjust assembly out of the slot in the actuator bar.
5. Push the inner wire into the brake cable housing until the brake pin, which presses
against the caster wheel surface, slides out of the caster mounting screw.
Callout
6. Remove the brake pin with spring from the inner brake cable wire.
Save the brake pin and spring for reassembly.
7. Pull the brake cable inner wire up far enough to be out of the way for removing the
caster mounting screw.
8. Unscrew the caster mounting screw, to remove the caster assembly from the cart body.
Retain the caster mounting screw and lock washer for mounting the new caster.
14766-000 Rev H
Description
A Shaft of pin slides inside
caster mounting screw
B Blunt end passes against
caster wheel
LD Cart Transporter User's Manual
D
A
C
B
Figure 10-25. Brake Pin
Callout
C
D
Chapter 10: Maintenance
Description
Flat top of blunt end retains
spring
Brake cable wire, with ball
end, fits into slot and hole
181