American Megatrends MegaDual User Manual page 28

Step 9 Connect I/O,
JP11 Floppy Connector JP11 is a 34-pin dual-inline berg. Connect the cable from the floppy drive to JP11, as
shown below. The onboard floppy controller cannot be used if a hard disk card with a
floppy controller is installed. Choose the Advanced menu (Floppy Configuration
subscreen) to configure the floppy controller.
The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½" drives and 360 KB
and 1.2 MB 5¼" drives. The connecting cable is a 34-pin ribbon connector with two 34-pin
edge connectors for attaching the floppy disk drives. There is a small twist in the cable
between the floppy connectors. The last (end) connector should be connected to floppy
drive A: as shown below.
22 MegaDual PCI Motherboard User's Guide
Continued
Cont'd