Chapter 8 - Alarm Connectors - American Dynamics Intellex Intellex LT Installation And Operating Instructions Manual

170
CHAPTER 8 — Appendices
ALARM
CONNECTORS
Alarm Connectors
Intellex
The alarm connectors accept up to 16 alarm inputs and 16 alarm
outputs. Use the information in this appendix to install your alarm
devices to the back of the unit.
NOTE: The polarity of all alarm inputs is programmable (see
Chapter 3 —System Setup
page 78). However, the polarity of all alarm outputs is
active-high. Also, the alarm outputs are initialized to
inactive low on power-up.
Figure 5 — Alarm Connectors on Rear Panel
Attach the alarm inputs, outputs and grounds to the connectors,
according to the pin assignments (refer to on page 171).
®
LT Digital Video Management System
on page 14 and Alarms Setup on