Sensor Adapter Configuration - Furuno FMD-3100 Instruction Manual

1. INITIAL SETTINGS AND ADJUSTMENTS
Item
[Alert Information
Source]
[ALF Text Informa-
tion]
[Sensor Network]
[Gateway Network]
[Radar Sensor]
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4.4

Sensor adapter configuration

A maximum of eight MC-3000S Sensor Adapters can be connected to the sensor
network. In case of the redundant configuration, sixteen sensor adapters can be
connected to the network. The MC-3000S can connect a max. ten additional units
(MC-3020D/MC-3030D).
1. Click [Sensor Adapter] on the menu bar.
*: Set the talker of the sentence output by the sensor adapter, [II] or [SI]. Normally,
keep the factory setting ([II]). Select [SI] only when it is necessary to change the
talker of the sensor adapter due to the connection with other devices.
1-20
Select source of alert definition information to be displayed on the
screen when alert occurrence is received in the ALF sentence.
• [Alert Definition]: Display according to the alert definition stored
in this equipment.
• [Alert Sentence]: Displays based on alert definitions included in
the ALF sentences.
Select the text information type of 2/2 packet of ALF sentence.
• [All Alert Name]: The 2/2 packet of the ALF sentence contains
all information of alert text. The text information of 2/2 packet of
the ALF sentence is displayed as an alert name in the alert list/
log.
• [Remaining Alert Name]: Alert text is split into 1/2 packet and
2/2 packet of the ALF sentence. The text information of the 1/2
packet and 2/2 packet of the ALF sentence is displayed as an
alert name in the alert list/log.
• [Decision Support]: The 2/2 packet of the ALF sentence in-
cludes the detailed information (Decision Support) of the alert.
Text information of the 2/2 packet of the ALF sentence is dis-
played as alert details of alert list/log.
Shows the IP address of the sensor network. Do not change the
setting.
Shows the IP address of the gateway network. Do not change the
setting.
Select the Equipment ID of the antenna unit connected with the
processor unit.
Remarks
* *