Furuno FMD-3100 Instruction Manual page 23

Item
[Equipment ID] Select the Equipment ID from the drop-down list.
The drop-down list options depend on the setting at [Sensor Setting].
[Details] Sets the serial communication format.
• [Baud rate]: Sets the baud rate. For
high-speed signal input (such as AIS
and Gyro), set the baud rate as 38,400
bps The available serial ports with com-
munication in 38,400 bps are [Serial 01]
and [Serial 02] (For sensor adapters,
[Serial 01] to [Serial 04]).
• [Data bit]: Sets the number of the data
bit.
• [Parity bit]: Select [Odd] or [Even] for the
parity bit. The parity bit is used in parity error checking to find errors
that may occur during data transmission. When you do not use the
parity bit, select [None].
• [Stop bit]: Sets the stop bit (last data bit location).
• [Timeout (sec)]
here, timeout alert occurs.
• [First Time]
of timeout until the sensor's first signal is detected after startup.
• [Continuation]
eout time until discovering that the signal is lost, after detecting the
initial signal.
• [Slave Address]
nication.
• [Input] button
the signal bit for each alert on the
[Modbus Input] window. On this win-
dow, alerts whose [Input Type] is set
for [MODBUS] when setting alert defi-
nition (see section 1.8.6) appear.
• [Forward sensor data]
checkbox to forward data input from
the serial port to the sensor adapter.
Normally keep the default setting (unchecked).
*1
Not shown for ECDIS, sensor adapter serial input/output setting
whose [Data Type] is selected to [MODBUS] (see section 1.4.1).
*2
Shown for the ECDIS, sensor adapter serial input/output setting
whose [Data Type] is selected to [MODBUS] (see section 1.4.1).
*3
Not shown for the sensors whose [Data Type] is selected to [MOD-
BUS] (see section 1.4.1).
[I/F monitor] Click [Start] to monitor the input signal sentences from the interface.
1. INITIAL SETTINGS AND ADJUSTMENTS
Remarks
*1
: When the data is not input during the time set
*2
: Check to activate and change setting. Set the amount
*2
: Check to activate and change setting. Set the tim-
*2
: Sets the slave address for the Modbus commu-
*2
: Sets the address and
*3
: Check the
1-17