Furuno FMD-3100 Instruction Manual page 97

17. At the "Switch#" line, input "write" then press the Enter key. This will save the
configuration.
Switch# config
Switch_config# ip igmp-snooping querier
Switch_config# show ip igmp-snooping
Global IGMP snooping configuration:
-----------------------------------
Globally enable
VLAN nodes
Dlf-frames filtering : Enabled
Sensitive
Querier
Querier address
Router age
Response time
Switch_config# write
Saving current configuration...
OK!
18. When the write process finishes, the HUB-3000 will restart.
19. Referring to steps 8 through 12, check to make sure the "Querier" line is showing
"Enabled". If the "Querier" line shows "Disabled", repeat the above procedure.
3. HUB-3000 IGMP QUERIER SETTINGS
: Enabled
: 1
: Disabled
: Enabled
: 10.0.0.200
: 260 s
: 15 s
3-3