Software Update] Menu - Furuno FMD-3100 Instruction Manual

1. INITIAL SETTINGS AND ADJUSTMENTS
1.12

[Software Update] Menu

You can update the software for the PCU-3010 and Trackball Control Unit RCU-030
on the [Software Update] menu. To update sensor adapter software, see section 2.3.
Note: To update the software with the update file, access the [Common Installation
Setting] menu via LAN connection. To update the software with the DVD, access the
[Common Installation Setting] menu with the Trackball Control Unit.
1. For LAN connection, connect the USB memory which has the update file to the
PC connected via LAN. For access with the Trackball Control Unit, insert the up-
date DVD in the DVD drive.
2. Access the [Common Installation Setting] menu and click [Software Update] on
the tab bar.
For the IP address of the unit to update, see the Equipment ID list at the back of
this manual.
3. Select the unit to update from the menu bar.
4. Click [Select File] to select the update, and then click [OK].
The current software version and updated software version are displayed.
5. Check the checkbox for the software to update.
6. Click [Update Software]. A confirmation message appears.
7. Click [OK] to update the software.
The progress bar shows the update progress. After completing the update, the
system is automatically rebooted.
8. If connected to the gateway network via LAN, the link is shown on the display
after completing the system reboot. Click the link on the display to access the
[Common Installation Setting] menu.
If connected to the sensor network, enter the IP address of the sensor network
to access the [Common Installation Setting] menu after completing the system
reboot.
1-52
2450118-xx.xx.xxxx
2450119-xx.xx.xxxx
2450074-xx.xx.xxxx
2450077-xx.xx.xxxx