Installation Parameters] Menu; Sensor Setting - Furuno FMD-3100 Instruction Manual

1. INITIAL SETTINGS AND ADJUSTMENTS
are connected to the same network, change the IP address of the RCB-002s, re-
ferring to "SUBSYSTEM" on page AP-3.
• [RCB00 (Main)] ( : 1 to 4): Input the location information of the external radar
antenna that is connected to the [RADAR SIGNAL IN No.1] port.
• [RCB00 (Sub)] ( : 1 to 4): Input the location information of the external radar
antenna that is connected to the [RADAR SIGNAL IN No.2] port. Set parame-
ters for the [RCB00 (Main)] before setting parameters for the [RCB00 (Sub)].
7. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4

[Installation Parameters] Menu

The [Installation Parameters] menu sets the signals and input data of the sensors.
First, select the sensor data at the [Sensor Setting] window. Then select the sensor
from which the units (radar sensor (antenna unit), MFD, ECDIS, radar, and sensor
adapter) obtain the sensor data.
1.4.1

Sensor setting

1. Access the [Common Installation Setting] menu and click [Installation Parame-
ters] on the tab bar.
2. Click [Sensor Setting] on the menu bar, then click [GPS Sensor].
3. Check applicable check boxes according to the number of GPS receivers con-
nected.
4. Set the following items for the units activated at step 3.
1-12
The time to timeout for receiving The time to timeout for receiving
data. Keep the default setting. data. Keep the default setting.