Peripherals] Window - Furuno FMD-3100 Instruction Manual

Note 3: [Serial No.] is entered before shipment. If you change the SSD or delete
[Serial No.] by mistake, click the [Serial No.] box to enter the serial number of the
PCU (example: xxxx-xxxx).
3. Confirm that [FMD-3100] is shown for [Equipment Type No.]. If not, select [FMD-
3100] from the [Equipment Type No.] drop-down menu.
4. Click [Save] on the info bar. Several confirmation messages appear. Click [OK] to
reboot the system. To discard all changes, click [Discard Changes].
1.2.2

[Peripherals] window

1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [Peripherals] on the menu bar.
1
* Shown when [FURUNO] or [NAVTOR] is selected in [Connection] of [Chart Service].
2
* Shown when [Connected] is selected in [Connection] of [Service Gateway].
3. Confirm that the menu items for [Monitor] are entered as follows.
[DVI1]
[DVI3]
4. Click the [Run] button for [Monitor Color Calibration] to perform the color calibra-
tion.
"Processing" appears at the next to the [Run] button during the color calibration.
After completing the calibration, check result appears ([Succeeded] or [Failed]).
When the check result is [Succeeded], the following confirmation message ap-
pears. Click the [OK] button to reboot the system and apply the calibration setting.
When the check result is [Failed], retry the color calibration. If the error is not rec-
tified, contact your dealer.
Note: Be sure to perform the color calibration. If the calibration is not performed,
you cannot adjust the monitor brilliance.
*1 *1
[Type Number]: [HD 24T21MMD (FHD)]
[Type Number]: [Not Connected (NONE)]
[Output Mode]: [Independent]
1. INITIAL SETTINGS AND ADJUSTMENTS
*2
1-5