Route Transfer] Window; Application] Window (Setting Is Not Required) - Furuno FMD-3100 Instruction Manual

1. INITIAL SETTINGS AND ADJUSTMENTS
1.2.4

[Route Transfer] window

1. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
2. Click [Route Transfer] on the menu bar.
3. To transfer data to a specified network, select [Connected] from the [Connection]
pull-down list.
[Connection]
[Transmission Rate]
[Network]
[Destination]
[Initial Value of Sequence
No.]
4. Click [Save] on the info bar. Several confirmation messages appear. Click [OK] to
reboot the system. To discard all changes, click [Discard Changes].
1.2.5

[Application] window (setting is not required)

Do not change the setting on the [Application] window of the [Basic Setting] menu.
Confirm that [Primary] is set to [ECDIS], if the setting is not [ECDIS], change it to [EC-
DIS].
1-8
Menu item
Select [Connected] to transfer the data.
Set the transmission rate.
Select the destination network for route data.
Set the IP address and port of the destination.
Set the initial value for the binary transmission
sequence number (IEC61162-450 compliant) to
be used when transferring route data to another
system.
Description