Connect The Power Supply; Connect The Gun Flush Box - Graco HydroShield Instructions Manual

Connect the the Power Power Supply
Connect Connect the Power
The power supply (47) with connector (X) is installed
at the factory on the back of the isolation cabinet.
Power cords with regional plugs are also supplied.
Use a supplied power cord or purchase a regional
plug separately.
1. Plug the power cord (Y) into the power supply
connector (X) at the cabinet.
2. Plug the pronged/male end of the power cord (Y)
into an AC outlet.
When the system is plugged in, the control
interface powers up in Off mode.
Figure 17 Power Supply Connections
3A7370C
Supply
Supply
Connect the the Gun Gun Flush
Connect Connect the Gun
Required Gun Required Required Gun Flush Gun Flush Box Flush
Additional parts or kits are required to add gun flush
box capability to a HydroShield system. The parts
needed depend on whether the model is equipped
for a gun flush box.
If the model is equipped for a gun flush box
(WMBH01, WMBH03, WMBH05, WMBH07,
WMBH41, WMBH43, WMBH45, WMBH47), the
following additional parts are required:
• Gun Flush Box Module, 244105. The module
comes with many parts, including:
– Graco manual 309227.
– 5/32 in. tube plug, 113279.
• Gun Flush Box Adapter Kit for 60 kV and 85 kV
Guns, 24N528.
• 5/32 inch tubing, 598095.
If the model is not equipped for a gun flush box
(WMBH00, WMBH02, WMBH04, WMBH06,
WMBH20, WMBH40, WMBH42, WMBH44) the
following additional parts are required:
• Gun Flush Box Modification Kit, 26B420. See
Accessories, page 132.
• 5/32 inch tubing, 598095.
Installation
Flush Box Box
Flush Box
Box Parts Box Parts Parts
23