Graco HydroShield Instructions Manual page 9

ELECTRIC ELECTRIC ELECTRIC SHOCK
This equipment must be grounded. Improper grounding, setup, or usage of the system can
cause electric shock:
• Turn off and disconnect power cord before servicing equipment.
• Connect only to grounded electrical outlets.
• Use only 3-wire extension cords.
• Ensure ground prongs are intact on power and extension cords.
• Do not expose to rain. Store indoors.
• Wait five minutes after disconnecting power cord before servicing.
• Ground all equipment, personnel, object being sprayed, and conductive objects in or close
to spray area. See Grounding
• Connect the electrostatic gun to a voltage isolation system that will discharge the system
voltage when not in use.
• All electrical wiring must be done by a qualified electrician and comply with all local codes
and regulations.
• Follow the Fluid
the voltage; before cleaning, flushing, or servicing the system; before approaching the front of
the gun; and before opening the isolation enclosure for the isolated fluid supply.
• Do not touch the gun nozzle or electrode, or come within 4 in. (102 mm) of the electrode
during gun operation. Follow the Fluid
• Only use the red-colored Graco electrically conductive gun air hose with this gun. Do not
use black or gray-colored Graco air hoses.
• Do not splice hoses together. Install only one continuous Graco waterborne fluid hose
between the isolated fluid supply and the spray gun.
MOVING PARTS
MOVING MOVING
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Equipment can start without warning. Before checking, moving, or servicing equipment,
follow the Pressure
SKIN INJECTION INJECTION HAZARD
SKIN SKIN INJECTION
High-pressure fluid from gun, hose leaks, or ruptured components will pierce skin. This may
look like just a cut, but it is a serious injury that can result in amputation. Get
treatment. treatment. treatment.
• Do not spray without tip guard installed.
• Engage trigger lock when not spraying.
• Do not point gun at anyone or at any part of the body.
• Do not put your hand over the spray tip.
• Do not stop or deflect leaks with your hand, body, glove, or rag.
• Follow the Pressure Relief Procedure when you stop spraying and before cleaning, checking,
or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses and couplings daily. Replace worn or damaged parts immediately.
3A7370C
WARNING WARNING WARNING
SHOCK HAZARD SHOCK HAZARD HAZARD
Grounding Grounding instructions.
Fluid Voltage Fluid Voltage Voltage Discharge Discharge Discharge and
PARTS HAZARD HAZARD
PARTS HAZARD
Pressure Relief Relief Procedure Procedure and disconnect all power sources.
Pressure Relief Procedure
HAZARD
HAZARD
and Grounding and Grounding Procedure Grounding Procedure when instructed to discharge Procedure
Fluid Voltage Voltage Discharge Discharge and
Fluid Voltage Discharge
and Grounding Grounding Procedure Procedure.
and Grounding Procedure
Get immediate Get immediate surgical immediate
Warnings
surgical surgical
9