Graco HydroShield Instructions Manual page 19

13. Tighten the strain relief nut (101c) and set screw
(101m).
Figure 9 Hose Connection at Enclosure
Figure 10 Hose Connection at Enclosure
3A7370C
Connect Connect the Connect the the Air Air Air Hose Hose from Hose
Cabinet Cabinet Cabinet
Connect the gun air hose between the air outlet (D)
on the isolation cabinet and the gun air inlet swivel
on the gun. Before beginning this procedure, the fluid
hose should be attached to the gun barrel and the air
inlet swivel should be positioned through the bracket
at the gun handle.
1. Install and tighten the air hose onto the gun air
inlet swivel.
Note
This fitting connection is a left-hand
thread.
2. Connect the air hose from the gun to the air outlet
(D) on the isolation cabinet.
Figure 11 Air Connection Location
3. The fitting on the air hose has a ground
connection for electrostatic guns. Attach the
other end of the ground wire to a true earth
ground. See Grounding, page
Installation
from Gun from Gun to to to the Gun the the
16.
19