Table of Contents
Advertisement
Installation
Connect the
the Power
Power Supply
Connect
Connect
the
Power
The power supply with connector (X) is installed at
the factory on the back of the isolation cabinet. A
power cord (Y) with an NEMA 5–15P plug is also
supplied.
1. Plug the power cord (Y) into the power supply
connector (X) at the cabinet.
2. Plug the pronged/male end of the power cord (Y)
into an AC outlet.
When the system is plugged in, the control
interface powers up in Off mode.
Figure 16 Power Supply Connections
22
Supply
Supply
Connect the
the Gun
Gun Flush
Connect
Connect
the
Gun
To use a gun flush box with the isolation system
requires the following parts:
• Gun Flush Box Module, part 244105.
• Graco manual 309227, included with 244105.
• Gun Flush Box Adapter Kit for 60 kV and 85 kV
Guns, part 24N528.
• 5/32 inch tubing or part 598095. See
Pneumatic Connections, page
• 5/32 inch tube plug or part 113279.
The gun flush box contains four pneumatic ports for
5/32 inch tubing.
Figure 17 Gun Flush Box Ports
Flush Box
Box
Flush
Box
77.
3A7370B
Advertisement
Table of Contents
