Installation; Power Supply Requirements; Connect The Power Supply; Grounding - Graco e-Xtreme Operation, Repair, And Parts

Installation

Installation
Installation Installation
To reduce the risk of electric shock, fire and
explosion, all electrical wiring must be done by a
qualified electrician and comply with all local codes
and regulations.
Power Supply Supply Requirements Requirements
Power Power Supply Requirements
See Driver Installation manual for instructions for

power supply requirements.

Connect the the Power Power Supply
Connect Connect the Power
See Driver Installation manual for instructions to

connect the power supply.

Grounding

Grounding Grounding
This equipment must be grounded to reduce the
risk of static sparking and electric shock. Electric
or static sparking can cause fumes to ignite or
explode. Improper grounding can cause electric
shock. Grounding provides an escape wire for the
electric current.
Sprayer: Sprayer: Sprayer: System is grounded through the power
cord.
Fluid hoses: hoses: Use only electrically conductive hoses
Fluid Fluid hoses:
with a maximum of 210 ft. (64 m) combined hose
length to ensure grounding continuity. Check
electrical resistance of hoses. If total resistance
to ground exceeds 25 mega ohms, replace hose
immediately.
Spray gun: gun: Ground through connection to a properly
Spray Spray gun:
grounded fluid hose and pump.
8
Supply
Supply
Fluid supply supply container: container: Follow local code.
Fluid Fluid supply container:
Object being being sprayed: sprayed: Follow local code.
Object Object being sprayed:
Solvent Solvent pails Solvent pails pails used used used when when flushing: when
code. Use only conductive metal pails, placed on
a grounded surface. Do not place the pail on a
non-conductive surface, such as paper or cardboard,
which interrupts grounding continuity.
To maintain maintain grounding grounding continuity
To To maintain grounding
relieving pressure: relieving relieving pressure: Hold the metal part of the spray pressure:
gun/dispense valve firmly to the side of a grounded
metal pail, then trigger the gun/valve.
Tools Required: Tools Tools Required: Required:
• Grounding wires and clamps for pails (Graco part
244524 – not supplied)
• Two 5 gallon (19 liter) metal pails (Graco part
101108 – not supplied)
1. Connect the ground wire (Y) to a ground stud on
the back of the motor.
2. Ground the object being sprayed, fluid supply
container, and all other equipment in the
work area. Follow your local code. Use only
electrically conductive air and fluid hoses.
3. Ground all solvent pails. Use only metal pails,
which are conductive, placed on a grounded
surface. Do not place pail on a non-conductive
surface, such as paper or cardboard, which
interrupts grounding continuity.
flushing: Follow local flushing:
continuity when when flushing flushing or or or
continuity when flushing
3A3164D