Operation; Operation Overview - Graco HydroShield Instructions Manual

Operation

Operation Operation

Operation Overview

Overview
Operation Operation Overview
1. Plug in the system. The system
powers up and enters Off mode. See
Connect the Power Supply, page
2. Verify that the fluid supply and air supply are
connected. Press the Power button
The system enters Standby mode.
3. Prime the system. Use the control interface
to change the mode to Prime mode. See
Home Screen, page
your material dispenses from the gun.
4. Use the control interface to set the air and fluid
pressure. See Home Screen, page
5. Use the control interface to change the mode
to Spray mode. The system begins to fill. See
Home Screen, page
6. Begin to spray.
Note
The system automatically refills when
the gun trigger is released and the fluid
level is below the Start Fill setting.
For information about the Start Fill setting, see
Pump Screen 1: Pump Volume, page
3A7370C
23.
.
49. Trigger the gun until
49.
49.
58.
Fluid Voltage Voltage Discharge Discharge and
Fluid Fluid Voltage Discharge
Grounding Procedure Procedure
Grounding Grounding Procedure
The fluid supply is charged with high voltage until
the voltage is discharged. Contact with the charged
components of the voltage isolation system or
spray gun electrode will cause an electric shock.
To avoid an electric shock, do not alter or bypass
the door switch interlock and follow the Fluid
Voltage Voltage Discharge Voltage Discharge and Discharge and Grounding and
• Whenever you are instructed to discharge the
voltage
• Before cleaning, flushing, or servicing the system
equipment
• Before approaching the front of the gun
• Before opening the isolation cabinet
1. Release the gun trigger and turn off electrostatics
by turning the ES ON/OFF valve on the back of
the handle to the OFF position.
2. Engage the trigger lock.
Operation
and
and
Fluid
Fluid
Grounding Procedure: Grounding Procedure: Procedure:
29