Graco HydroShield Instructions Manual page 22

Installation
2. The system is equipped with another CAN
cable (43) that is used to connect to the control
interface:
On On systems On systems systems that that are that are not are
a. Screw one end of the cable (43) into the
fitting on the right side of the cabinet.
b. The bottom of the controller contains two
fittings. Screw the other end of the cable (43)
into the fitting as shown below.
Figure 15 Connections on the Control Interface
(Systems without Color Change)
On On systems On systems that systems that are that are are color
a. Screw cable (611) into C4 on the color
change module. See the parts figure in
Color Change Components, page 135
Color Change: Pneumatic and Wiring
Connections, page
b. Connect C5 from the color change module to
the control interface.
3. Insert the controller into the bracket (41) on the
top of the cabinet.
22
not color not color change color change enabled: change enabled: enabled:
color change color change enabled: change enabled: enabled:
and
118.
To mount the controller in another location, remove
bracket (41) from the system and mount it in
a convenient location. For information about
available alternate length CAN cables, see
Accessories, page 132.
Figure 16 Bracket (41) Mounting Holes
3A7370C