Henny Penny SmartCombi ESC 615 Replacement Instructions Manual page 13

SmartCombi™ & ClassicCombi™ Service
Assembling:
Software configuration
To enter the Service menu do the following:
1. Switch the unit on
2. Press Flexi button and choose with the upper knob
Par
3. Press Start/ Stop- Button and on the lower displays
shows
4. Enter Password
777
5.
Press Start/ Stop- Button
on the lower display.
6.
Select
START/ STOP. Must flashing in the upper display now.
2
must flashing in the upper display now. You are now
in the unit configuration.
X12
6
Assignment (* = only at optional 4 point core temp. probe)
Check connector [6] and replace if damaged.
➢
Mount new control pcb.
➢
Mount earth screw[3] interconnects both pcb´s).
➢
Mount plugs and protection cover (if available).
➢
Close and lock front panel.
➢
Switch on the power supply and carry out the configuration.
➢
(parameter)
000
.
with the lower knob
S0F
UCF
with the lower knob and confirm with
B1 B2
(Software) is shown
X11
B3 B4
Par
000
777
S0F
UCF
Page 2 of 4
13