Table of Contents
Advertisement
CA UTI O N
CA UTI O N
Installation
Humidity:
Up to 95% relative humidity to 40
from temperature extremes which may cause condensation.
This instrument is designed for use in Installation Category II and Pollution Degree 2
per IEC 61010 and 60644 respectively.
This instrument has an external dc charger unit which has an autoranging line voltage
input. Ensure the line supply is within the range 100 to 240 V ac.
Safety Precautions for the User
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the instrument. Agilent
Technologies, Inc. assumes no liability for the customer's failure to comply with
these requirements.
In particular, the operator should note the following safety information:
• "Safety Symbols" on page 2-4.
• "Connecting the dc Charger to the ac Power Supply" on page 2-6.
• "Operating Environment" on page 2-2.
• "Battery Replacement" on page 2-6.
• "User's Maintenance" on page 2-8.
DO NOT operate damaged equipment: Whenever it is possible that the safety
protection features built into this product have been impaired, either through
physical damage, excessive moisture, or any other reason, REMOVE POWER and
do not use the product until safe operation can be verified by service-trained
personnel. If necessary, return the product to an Agilent Sales and Service Office for
service and repair to ensure the safety features are maintained.
o
C, but it should be protected
2-3
Advertisement
Table of Contents
