Table of Contents
Advertisement
NO T E
Results
Logging Results to a PC
4 Using an RS-232-C (male-to-female) crossover cable, connect the PRINTER
port of ProBER 2 to the COM X port of your PC. Here are the pin connections:
1 DCD
2 RD
3 TD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
24542U is a suitable cable.
5 On your PC, get your Hyperterminal (it may be installed as part of your
Accessories), or alternative, and set up as follows:
Setup:
COMX (e.g. COM1, as appropriate for your PC)
Bits Per Second: 9600
Data Bits
8
Parity:
None
Stop Bits:
1
Flow Control:
Xon/Xoff
6 To capture text to a file, select Transfer from the main menu, then Capture
Text . . .. Enter a name for the capture file and then press Start.
7 On ProBER 2, press
provide setup information to the file.
8 Press
START/STOP
results you selected in the Filters Setup in step 3, above.
9 To stop the data transfer, on the PC select Transfer from the main menu, then
Capture Text . . ., then Stop.
10 The file may be viewed using any text editor, e.g. NotePad.
The
key on ProBER 2 does not work in this procedure.
PRINT
7-10
Not used
to start a measurement. ProBER 2 will
START/STOP
to stop the measurement. ProBER 2 will provide all the
1 DCD
2 RD
3 TD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Advertisement
Table of Contents
