Table of Contents
Advertisement
Results
Logging Results to a Printer
Error Counts - Log all valid error counts (Bit, Code, FAS, CRC, E-bit).
Alarm Seconds - Log Alarm Seconds.
G.821 - Log chosen G.821 results (All, Bit, FAS, CRC or E-Bit).
G.826 - Log chosen G.826 results (All, In-Service or Out of Service).
M.2100 - Log chosen M.2100 results (All, M.2100, M.2110, M.2120).
Frequency - Log the received frequency.
Signal Level - Log the received signal level.
Each or all of these Filters can be switched
3 Select
, as shown, and choose the logging Setup.
Setup
Logging Mode - Enables logging.
Log Errored Secs - Provides a timed and dated message each time an error or
alarm occurs.
Logging Interval - Choose the interval for logging results to the printer. If
is chosen use
,
Log When - Log always or only when error count is greater than zero.
7-6
OFF
,
and
to choose the logging interval.
.
User
Advertisement
Table of Contents
