Autosetup - Agilent Technologies ProBER 2 User's Reference Manual

Hide thumbs Also See for ProBER 2:

Table of Contents

Description:

NOT E

Setting the Interfaces

AutoSetup

ProBER 2 can be configured to match the received signal using the

feature.

When

AUTOSETUP

detect the line rate. If 2.048 Mb/s or 64 kb/s is not detected, AutoSetup will halt and

Signal Loss will be indicated.

If 2.048 Mb/s or 64 kb/s is detected, ProBER 2 will attempt to match the framing

present on the received signal. If PCM30, PCM31, PCM30CRC or PCM31CRC is

not detected, it will be assumed the received signal is Unframed.

ProBER 2 will next check for a valid test pattern in the received signal.

If a valid test pattern is not detected, the Line Rate and Framing settings will be

retained.

1. If a measurement is running under the control of Test Timing, this must be halted

by pressing

START/STOP

2. If AutoSetup is running and you wish to make a measurement under the control of

Test Timing, Autosetup must be halted by pressing

3. If ProBER 2 does not find a recognizable test pattern distributed across all the

timeslots in a 2 Mb/s signal, it will terminate its search.

is pressed, ProBER 2 will monitor the received signal to

before AutoSetup can be used.

AUTOSETUP

4-5

Table of Contents