DAP-300P Wireless N300 PoE Access Point / Router
User Manual
CHAPTER 4.
INTERFACE
Initial Configuration Wizard
To start the Initial Configuration Wizard, go to the Initial Configuration section. On the opened
page, click the OK button and wait until the factory default settings are restored.
If you perform initial configuration of the access point via Wi-Fi connection, please make sure that
you are connected to the wireless network of DAP-300P (see the WLAN name (SSID) on the
barcode label on the bottom panel of the device) and click the NEXT button.
Click the START button.
CONFIGURING
Figure 31. Restoring the default settings in the Wizard.
Figure 32. Checking connection to the wireless network.
Figure 33. Starting the Wizard.
Page 43 of 175
Configuring via Web-based Interface
VIA
WEB-BASED