Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
WAN
This page is available if the Router or WISP Repeater mode was selected in the Initial
Configuration Wizard.
On the Connections Setup / WAN page, you can create and edit connections used by the access
point.
To create a new connection, click the ADD button (
that the connection creation page opens
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, on the Basic tab, the mandatory settings of this WAN connection will
be displayed. To view all available settings of the WAN connection, go to the All Settings tab.
Change the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button (
connection on the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, click the IGMP link (for the
description of the page, see the IGMP section, page 139).
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the Default
Gateway section, select the choice of the radio button which corresponds to this connection.
3 Setting up PPPoE, PPTP, L2TP, PPoE IPv6, and PPPoE Dual Stack WAN connections on the Connections
Setup / WAN page will become available in future software versions.
Figure 71. The Connections Setup / WAN page.
3
.
Page 80 of 175
Configuring via Web-based Interface
) in the Connections List section. Upon
). Also you can remove a
Advertisement
Table of Contents
