DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Telnet
On the System / Telnet page, you can enable or disable access to the device settings via TELNET
from your LAN. By default, access is disabled.
To enable access via TELNET, move the Enable Telnet switch to the right. In the Port field, enter
the number of the access point's port through which access will be allowed (by default, the port 23
is specified). Then click the APPLY button.
To disable access via TELNET again, move the Enable Telnet switch to the left and click the
APPLY button.
Figure 133. The System / Telnet page.
Page 164 of 175
Configuring via Web-based Interface