Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Parameter
Autonegotiation
20/40 (Coexistence)
TX power
B/G protection
Short GI
Beacon period
RTS threshold
Frag threshold
DTIM period
Move the switch to the right to let the access point automatically
choose the most suitable channel bandwidth (20MHz or 40MHz) for
the connected devices (this setting can substantially lower the data
transfer rate of your wireless network). The switch is displayed when
the 20/40 MHz value is selected from the Bandwidth drop-down
list.
The transmit power (in percentage terms) of the access point.
The 802.11b and 802.11g protection function is used to minimize
collisions between devices of your wireless network.
Select a value from the drop-down list.
•
Auto: The protection function is enabled and disabled
automatically depending on the state of the network (this
value is recommended if your wireless local area network
consists of both 802.11b and 802.11g devices).
•
Always On: The protection function is always enabled (this
setting can substantially lower the efficiency of your wireless
network).
•
Always Off: The protection function is always disabled.
Guard interval (in nanoseconds). This parameter defines the interval
between
symbols
communicating to wireless devices.
•
Enable: the access point uses the 400 ns short guard
interval. Only for the wireless network operating modes
which support 802.11n standard (see the value of the
Wireless mode drop-down list on the Wi-Fi / Basic
Settings page).
•
Disable: the access point uses the 800 ns standard guard
interval.
The time interval (in milliseconds) between packets sent to
synchronize the wireless network.
The minimum size (in bytes) of a packet for which an RTS frame is
transmitted.
The maximum size (in bytes) of a non-fragmented packet. Larger
packets are fragmented (divided).
The number of beacon frames between sending DTIM messages
(messages notifying on broadcast or multicast transmission).
Page 109 of 175
Configuring via Web-based Interface
Description
transmitted
when
the
access
point
is
Advertisement
Table of Contents
