Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
9. In the opened Wireless Network Connection window, select the wireless network DAP-
300P and click the Connect button.
10. In the opened window, enter the network key (see WPS PIN on the barcode label on the
bottom panel of the device) in the Security key field and click the Next button.
11. Allow or forbid your PC to be discoverable by other devices on this network (Yes / No).
12. Wait for about 20-30 seconds. After the connection is established, the network icon will be
displayed as a dot with curved lines indicating the signal level.
Now you can connect to the web-based interface of DAP-300P for configuring all needed
parameters. To gain access to an external network (to the Internet), you also need to specify the
default gateway and the addresses of DNS servers.
If you perform initial configuration of the access point via Wi-Fi connection, note that
!
immediately after changing the wireless default settings of the access point you will need
to reconfigure the wireless connection using the newly specified settings.
Figure 23. The list of available networks.
Figure 24. PC discovery settings.
Page 35 of 175
Installation and Connection
Advertisement
Table of Contents
