Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
Parameter
Max associated clients
Broadcast wireless
network
Clients isolation
Enable guest network
In the Security Settings section, you can change security settings of the wireless network.
By default, the WPA2-PSK network authentication type of the wireless network is specified. WPS
PIN from the barcode label is used as the network key.
Figure 84. Network authentication types supported by the access point.
The access point supports the following authentication types:
Authentication type
Open
WEP
WPA
The maximum number of devices connected to the wireless network.
When the value 0 is specified, the device does not limit the number
of connected clients.
If the switch is moved to the left, devices cannot connect to the
wireless network. Upon that the access point can connect to another
access point as a wireless client.
Move the switch to the right to forbid wireless clients of this
wireless network to communicate to each other.
This function is available for the additional network. Move the
switch to the right if you want the devices connected to the
additional network to be isolated from the devices and resources of
the access point's LAN.
Open authentication (with WEP encryption for wireless network
modes not supporting 802.11n devices).
Authentication with a shared key with WEP encryption. This
authentication type is not available when a mode supporting
802.11n devices is selected from the Wireless mode drop-down
list on the Wi-Fi / Basic Settings page.
WPA-based authentication using a RADIUS server.
Page 95 of 175
Configuring via Web-based Interface
Description
Description
Advertisement
Table of Contents
