Table of Contents
Advertisement
TRENDnet User's Guide
Multiple WAN Configuration
Multiple WAN Management Settings
System > WAN Setup / System > WAN Traffic Setup
The section provides an overview of the multiple WAN management settings and the
multi-WAN mode functionality.
1. Log into your router management page (see
on page 7).
2. Click on System and click on WAN Setup.
© Copyright 2019 TRENDnet. All Rights Reserved.
"Access your router management
page"
3. Review the settings below.
• WAN Port – The router can operate in two modes.
o
4 WAN / 1 LAN Port: 4 WAN (Ports 2-5) / 1 LAN (Port 1) or multi-WAN
mode.
Note: Please note that performance throughput is limited of up to
200Mbps per WAN connection in multi-WAN mode.
o
1 WAN / 4 LAN Port: 1 WAN (Ports 1) / 4 LAN (Ports 2-5)
Note: Please note that the 4 LAN ports function as a 4-port LAN switch
with a single IP interface, not as 4 individual LAN interface ports.
• Primary Port – In multi-WAN mode, this setting configures the primary WAN port
used for Internet connectivity.
• NAT Engine (1 WAN / 4 LAN Port Mode Only) – When this setting is enabled, NAT
hardware acceleration is enabled providing maximum NAT
throughput/performance. It is recommended to leave this setting enabled.
4. Click Save at the bottom. Then click Reboot at the top right to commit the changes.
TWG-431BR
35
Hide quick links:
Advertisement
Table of Contents
