TRENDnet TWG-431BR User Manual page 28

TRENDnet User's Guide
4. Click Save at the bottom. Then click Reboot at the top right to commit the changes.
5. Click on Advanced, click on IP Routing Rule Setup, and next to the first entry, and
click Edit.
6. Review the Routing section.
• Service: Select Enable to enable the route or disable to disable the route.
• Destination Net/Mask: Enter the IP network address of the destination network
for the route or network to distribute for the RIP/OSPF protocol (e.g.
192.168.150.0/24)
• Via
o
Gateway: This option configures that static route to an external IP
network and specify the gateway IP address. If choosing this option,
enter the Gateway IP address. (e.g 192.168.10.2)
o
Interface: This option configure an interface route. If choosing this
option, click the drop-down list and select the interface.
• Metric: Enter the metric or priority of the route. The metric range is 1-255, the
lowest number 1 being the highest priority.
• RIP – Selecting Enable will distribute the network route to other RIP enabled
devices.
• OSPF – Selecting Enable will distribute the network route to other OSPF enabled
devices.
© Copyright 2019 TRENDnet. All Rights Reserved.
You can check the current routing table Advanced > IP Routing Status.
6. Click Save at the bottom. Then click Reboot at the top right to commit the changes.
TWG-431BR
20