TRENDnet TWG-431BR User Manual page 7

TRENDnet User's Guide
LED Indicators
LED Description
Solid Green – Device is ready and receiving power.
Power
Off – Device is not powered or not ready.
Status Refer to USB mode section for functionality.
Storage Refer to USB mode section for functionality.
LED r
Gigabit Ports 1-5 Solid Green – Port is connected at 10Mbps/100Mbps/1Gbps
LED link speed.
Blinking Green - Data activity/transmission on port.
Off – Port is disconnected or no link.
© Copyright 2019 TRENDnet. All Rights Reserved.
Port/Button Description
Ports/Buttons Description
RJ-45 Console Using the included RJ-45 to RS-232 console cable, this
Port interface provides console/terminal (command line interface)
access to the device for management and troubleshooting
purposes.
Terminal Settings:
Baud: 57600 / Data: 8 / Stop: 1 / Parity: None / Flow: None
USB 3.0 Port Allows for an optional USB storage device (flash drive,
external HDD, etc.) to be connected and used for
configuration backup and export logging. (FAT32/NTFS
format only)
Gigabit Ports 1-5 By default, port 1 is configured as the LAN port and ports 2-5
are configured as WAN ports.
The ports can operate in two modes, 1 x LAN / 4 x WAN or 4 x
LAN / 1 x WAN.
By default, management access to the GUI and command line
interface via default LAN IP address: 192.168.10.1 /
255.255.255.0
The WAN port(s) connect your ISP(s) equipment for Internet
connectivity such as modem. By default, WAN1 (port 2) is
configured as the primary WAN interface and all WAN
interfaces are configured in load balance mode.
Reset Button Resets device to factory defaults. Using a paperclip, push and
hold the reset button for 15 seconds and release to reset the
device to factory defaults.
Power Port Connects the included power adapter to supply device
power.
On(-)/Off(o) Turns the device power On(-) or Off(o).
Power Switch
TWG-431BR
4