TRENDnet User's Guide
5. If the router is configured in multi-WAN mode, click on System and click on WAN
Traffic Setup to configure the load balance settings.
Note: For WAN failover, the router will use the primary WAN port configured under
System > WAN setup as the primary WAN port for Internet connectivity and failover to
the next available active WAN link if the primary WAN link fails.
• Mode – Select the load balance mode for the multiple WAN interfaces to operate.
o
Assign Weight – This mode will allow you to configure a percentage
assignment for each WAN interface.
o
Connection Mode – Select the mode for the router to determine how
to send sessions out multiple WAN interfaces.
▪
Source IP based – In this mode, if a device sends traffic
through the router and forwarded to a specific WAN
interface, the router will attempt to keep all future sessions
originating from that device (source IP) on the same WAN
interface.
▪
Source-Destination IP based - In this mode, if a device sends
traffic through the router to a specific destination IP address
and forwarded to a specific WAN interface, the router will
attempt to keep all future sessions originating from that
device (source IP) along with same destination IP address on
the same WAN interface.
▪
Per session – In this mode, the router will randomly choose
which WAN interface to forward the traffic based on each
session. This may cause connectivity/stability issues with
some applications or devices.
o
WAN Weight – The weight is distributed as percentage across all WAN
interfaces. Enter a number 1-10 to assign the WAN weight. The higher
© Copyright 2019 TRENDnet. All Rights Reserved.
the number/percentage, the more the router will utilize the WAN for
more traffic and sessions.
• Line Speed Weight – The mode allows you to specify the max. bandwidth allocated
for each WAN interface.
o
Line Speed Weight – Enter the upload and download bandwidth for
each WAN interface in Kbps.
TWG-431BR
36