Table of Contents
Advertisement
TRENDnet User's Guide
Configure WAN interfaces for Internet connectivity
System > WAN Setup
By default, the WAN configuration is set to WAN load balance equally across all WAN
interface and use WAN1 as the primary connection for Internet connectivity. WAN
failover to the next active WAN interface if connection WAN1 fails. This section will
explain how to set up the WAN interfaces for Internet connectivity to your ISP (Internet
Service Provider).
IMPORTANT NOTE: The default mode for the interfaces is 1 x LAN / 4 x WAN. In this
mode, NAT throughput/performance will have a performance limitation of 200Mbps per
WAN interface.
1. Log into your router management page (see
on page 7).
2. Click on System and under DNS, enter primary and secondary IP addresses of the DNS
servers provided by your ISP (Internet Service Provider), then click Save.
Note: Please note that the router will use one set of DNS servers for all WAN interfaces.
3. Under the WAN List next to WAN1, click Edit.
© Copyright 2019 TRENDnet. All Rights Reserved.
"Access your router management
page"
4. Under the WAN Settings, click the Mode drop-down list and select the Internet
connection provided by your ISP.
5. Click Save at the bottom. Then click Reboot at the top right to commit the changes.
TWG-431BR
14
Hide quick links:
Advertisement
Table of Contents
