JUKI AC-172N-1790AN Instruction Manual page 88

No.
1st bar-tacking length
This item sets length of bar-tacking on the rear
side.
Square
type, bar-tack,
bottom
Compensation of bar-tacking width, right
This item adjusts left side outer shape of
bar-tacking section in terms of overedging sec-
tion.
Both 1st and 2nd bar-tacking can be compen-
sated.
Square
type,
top
Compensation of bar-tacking width, left
This item adjusts left side outer shape of
bar-tacking in terms of overedging section.
Flow bar-tacking offset, left
This item sets length to form bar-tacking sec-
tion of flow bar-tacking shape.
Flow bar-tacking offset, right
This item sets length to form bar-tacking sec-
tion of flow bar-tacking shape.
Eyelet shape length
This item sets upper side length from center of
eyelet of eyelet shape.
Number of stitches of eyelet shape
This item sets number of stitches in the upper
90° of eyelet shape.
Eyelet width
This item sets crosswise size of the inside of
eyelet shape.
Actual needle entry point is the dimension to
which
ed.
Eyelet length
This item sets lengthwise size of the inside of
eyelet shape.
Round type shape length
This item sets upper side length from the cen-
ter of round type shape.
Number of stitches of radial shape
This item sets number of stitches in the upper
90° of radial shape.
Reinforcement of radial shape
This item sets with / without reinforcement
of radial shape.
stitching
: With
(Remarks)
1 : Displayed according to the shape.
2 : Displayed when it is set to with edit.
Refer to "II-2-10. Setting procedure of sewing data with/without edit"
3 : Displayed when the function is selected.
Item
Flow,
Straight
bottom
bottom
Square Straight
type, bar-tack,
bottom bottom
Knife groove width, left is add-
: Without
Setting
range
0.2 to 5.0
-1.00 to 1.00
-1.00 to 1.00
0.00 to 3.00
0.00 to 3.00
1.0 to 10.0
1 to 8
1.0 to 10.0
1.0 to 10.0
1.0 to 5.0
1 to 8
---
− 84 −
Edit unit Remarks
0.1mm ---
0.05mm ---
0.05mm ---
0.05mm * 1
0.05mm * 1
0.1mm * 1
1 * 1
0.1mm * 1
0.1mm * 1
0.1mm * 1
1 * 1
--- * 1, * 2
p.93.