Brown
❼
Degrease
Black
Blue
7)
Insert material edge detecting sensor asm. cord
❼ into material edge detecting sensor junction
cord .
8)
Degrease the top surface (at the location where
reflective sheet is to be affixed) of feed plate
.
Affix reflective sheet on feed plate aligning
9)
with the end face of the slot of the feed plate.
If the relevant part of the surface of feed
plate is not adequately degreased,
reflective sheet is likely to come un-
stuck.
– 14 –
4)
Secure material edge detecting
sensor cord by means of cable clip
together with the hand-switch
cord and the air hose.
5)
Open the cover of the control box.
6)
Connect brown cord (contact) of
the material edge detecting sensor
junction cord to sensor junction
cord B asm. (CN105-30), black
cord (contact) to sensor junction
cord B asm. (CN105-26) and
blue cord (contact) to sensor junc-
tion cord B asm. (CN105-27),
respectively.