Table of Contents
Advertisement
No.
Presser lifter motor origin
compensation
Thread trimming on the way in continuous
stitching Permitted/ Prohibited.
In case of prohibited, jump feed setting becomes in-
valid, and the registered pattern is sewn at the same
position. Then multi-sewing is possible.
: Permitted
Release amount of bobbin thread
trimmer at the start of sewing
This item sets the amount of releasing
the bobbin thread trimmer at the start of
sewing.
Presser lifter speed selection
As set value is increased, presser lifting
speed becomes faster.
Material edge detecting sensor setting
:Material
edge sensor
is disabled
Marking light setting
: Marking
light is dis-
abled
Auxiliary clamp setting
: Auxiliary
clamp is
disabled
Material edge detecting sensor positioning
Adjust the distance between the needle
entry point and the location at which
the material edge detecting sensor de-
tects the material edge so that the jump
amount equals to the set value.
Delay from the lift of the presser foot
to the start of carrying
Delay from the closing of the upper /
lower clamps to the turning-off of the
vacuum
Work clamp error detecting position
E083
The height at which the work
clamp height error is detected is set.
* If it is set at zero (0), the error will not
be detected.
Setting of the holding power of Y-feed motor
：Low
Item
: Prohibit
: Mate-
rial edge
sensor is
enabled
: Marking
light is en-
abled
: Auxiliary
clamp is
enabled
：Medium
：High
− 116 −
Setting range
Edit unit
-100 to 10
1 pulse
(0.05 mm)
---
---
1 to 15
1 pulse
1 to 3
1
---
---
---
---
---
---
30.0 to 100.0
0.1 (0.1mm)
0 to 1000
50 msec
0 to 1000
50 msec
0 to 10.0
0.1
---
---
Initial display
0
Permitted
8
1
Material edge
sensor is dis-
abled
Laser marker
is disabled
Auxiliary
clamp is dis-
abled
65.0
0
0
3.0
Low
Advertisement
Table of Contents
