Table of Contents
Advertisement
D
Set the amount of feed from the material edge C at 65
3)
mm under the AC mode.
4)
Press the ready key to bring the sewing machine into
C
the sewing state. Then, place a piece of cloth of approxi-
mately A4-size(210mmx297mm) on the preset section.
5)
Actuate the preset device to start sewing.
Measure the distance D from the material edge to the
6)
edge of a buttonhole. Enter the measured value in the
field above the K26 pictograph. (Initial value is 65 mm.)
7)
Now, the positioning of the sensor is completed. Enter
the desired amount of feed in C and measure the afore-
mentioned distance for the purpose of confirmation.
– 16 –
Advertisement
Table of Contents
