12) Open the control box. Connect solenoid valve cord to the CN 106 connectors (red: 19-pin, black: 20-
pin).
* Carefully check the wiring location of the red and black connectors.
13) Install right cover ❷ and secure with screws ❶ .
❶
❷
❶
14) Fit material presser rubber cushion on clamp
. (Fit the cushion to the side which has a
shorter distance from the bent section to the
end face.)
15) Insert clamp into clamp block and secure
with two setscrews . At this time, adjust so
that setscrews are brought to the location of
the slot in the top surface of clamp .
– 22 –