Table of Contents
Advertisement
7
7.8 INSTALLATION OF THE COOLING FAN BELT DRIVE
7.8.1 Assembling the fan belt drive pulleys
1. Check that all components are intact and, if necessary,
replace them with original spares.
2. Mount the pulley (G1) and fasten the screws without
tightening them.
3. Tighten the screws in a crisscross pattern to a final
torque of 10 Nm.
4. Mount tool "7107-1460-051" to inhibit rotation of the
crankshaft.
5. Apply some anti-seize product to the screw thread (L).
Warning
• The screw is left-handed. Turn anticlockwise to
screw.
6. Tighten the screw (L) to a torque of 180 Nm.
7. Remove the tool (M).
8. Install the starter motor (N) and tighten the screws to
a torque of 45 Nm.
80
INSTALLATION OF ASSEMBLIES
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
G1
131
M
132
133
L
N
M
Advertisement
Table of Contents
