Table of Contents
Advertisement
8.1 RACCOMMENDATIONS FOR REPLACING PARTS
- This chapter describes the procedures for replacing a
number of components and/or assemblies which are
not recommended for repairs.
- Some of these operations are also contained in the
user's operation and maintenance manual.
- Before any intervention, the operator should lay out all
equipment and tools in such a way as to enable him to
carry out operations correctly and safely.
- Before proceeding with operations, make sure that
appropriate safety conditions are in place, in order to
safeguard the operator and any persons involved.
- All operations, except where expressly stated otherwise,
must be carried out when the engine is not running and
has cooled sufficiently to avoid the risk of burns.
8.2 REPLACING THE ALTERNATOR - FAN BELT
Important
• Replacement may be carried out with the engine
installed on the machine.
The engine may have an external or internal alternator.
With external alternator
1. Switch off the engine and leave to cool.
2. Loosen the nuts (B - B1).
3. Loosen the belt by adjusting the alternator manually
and tighten the nut (B1).
4. Slip off the belt (D) and replace it with an original spare.
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
REPLACING PARTS
Important
• To locate specific topics, the reader should refer to the index.
142
D
143
B
B1
8
85
Advertisement
Table of Contents
