Table of Contents
Advertisement
4.6 PREPARING THE ENGINE FOR OPERATION (INSTALLED)
After a period of inactivity and before installing and running
the engine, it is necessary to carry out a few measures in
order to ensure that it runs at maximum efficiency.
1. Use a cloth soaked in degreasing product to remove the
external protective treatment.
2. Adjust the alternator-fan belt tension.
3. Make sure that electrical contacts are intact and efficient.
4. Check the filters for aging (air, oil, fuel) and, if necessary,
replace them with original spares.
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
STORING THE ENGINE
Important
• Over time, a number of engine components and lubricants
lose their properties, even when the engine is not in use, and
so it is important to consider whether they need replacing,
based not only on the number of hours of use, but also on
age and wear.
5. Check that the engine oil and coolant are up to level.
6. Start the engine and keep at minimum speed for a few minutes.
7. Check for leaks and, if necessary, find and eliminate the cause.
8. Switch off the engine.
4
29
Advertisement
Table of Contents
