Toshiba e-STUDIO2010AC Imaging Manual page 20

1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
It is recommended that the changing amount for one time falls within ± 20 bits.
(b) Select [05 ADJUSTMENT MODE], select code [2742] and then press the [START] button.
After performing image quality control, print the image and check its quality on the solid areas.
(2) Select [08 SETTING MODE]. Change the value to adjust the density of a solid area during the
copying/printing operation.
Use steps (a) to (b) to perform the adjustment.
(a) Select [08 SETTING MODE]. Change the values for codes [2513/2514] to adjust the developer
bias output value.
The value to use varies depending on the paper type and color to adjust. Check the code to use
in accordance with the following "Code" list, and refer to the "Code setting values" list to select a
proper value.
Code
Paper type
Plain / Recycled /
Thick / Thin paper*
Except
extra long
size paper
Other paper
Extra long size paper*
• The table below shows you the acceptable paper weight for the paper type.
Paper type
Plain/Recycled paper
Thick paper
Thin paper*
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Color to adjust
Y (yellow)
M (magenta)
C (cyan)
K (black)
Y (yellow)
M (magenta)
C (cyan)
K (black)
Y (yellow)
M (magenta)
C (cyan)
K (black)
Acceptable paper weight
60 to 80 g/m²
81 to 105 g/m²
52 to 59 g/m²
© 2018 TOSHIBA TEC CORPORATION All rights reserved
1-8
[08] code Subcode
0
1
08-2513
2
3
0
1
08-2514
2
3
0
1
08-2514
2
3
Max. 60 lb. Cover
Max. 110 lb. Index
14 to 16 lb. Bond