Toshiba e-STUDIO2010AC Imaging Manual page 115

(3) Perform color balance adjustment or RGB adjustment to adjust the tint of the colors in general.
For further information regarding the adjustment procedures, refer to procedure (3) in "2.3 To
Closely Match the Color Balance of the Original".
After adjusting the tint of colors, copy and check the copy image quality. If further image quality
adjustments are still necessary, the service technician must perform the next procedure.
(4) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
Original Color to
mode adjust
Y (Yellow)
M (Magenta) 05-7965
Text/Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7966
Text
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7967
Printed Image
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7968
Photo
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7969
Map
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7981
User Custom
C (Cyan)
K (Black)
Y (Yellow)
M (Magenta) 05-7985
Red Seal
Color
C (Cyan)
K (Black)
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
• The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Subcode
0
1
2
© 2018 TOSHIBA TEC CORPORATION All rights reserved
[05] code Subcode
05-7960 0/1/2
0/1/2
05-7970 0/1/2
05-7975 0/1/2
05-7961 0/1/2
0/1/2
05-7971 0/1/2
05-7976 0/1/2
05-7962 0/1/2
0/1/2
05-7972 0/1/2
05-7977 0/1/2
05-7963 0/1/2
0/1/2
05-7973 0/1/2
05-7978 0/1/2
05-7964 0/1/2
0/1/2
05-7974 0/1/2
05-7979 0/1/2
05-7980 0/1/2
0/1/2
05-7982 0/1/2
05-7983 0/1/2
05-7984 0/1/2
0/1/2
05-7986 0/1/2
05-7987 0/1/2
Area where the density is adjusted
Low density area
Middle density area
High density area
2-61
2.Copier-specific Adjustments
Recommended value
Set a value larger than
128 to increase the
density.
Set a value smaller than
128 to decrease the
density.
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Acceptable
Default
value range
0 to 255 128