Toner Used Amount Adjustment - Toshiba e-STUDIO2010AC Imaging Manual

3.Printer-specific Adjustments
3.1.9

Toner Used Amount Adjustment

When printing on paper with a rough surface, the problem of the toner coming off of can be suppressed
from dark lines created by overlapping of the 4 color toners.
PCL PS XPS
Select [05 ADJUSTMENT MODE] and change the setting value for [8070]/[8071] or [8089]/[8090] to a
smaller one, so that the limit value of the maximum toner adhering amount will become small.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and
Halftone).
• Printing on Mac is performed in PostScript.
Resolution Halftone
Smooth
600 dpi
Detail
Smooth
1200 dpi
Detail
• Set the value in increments of approximately 30, while checking the printouts until the optimum
value is obtained.
Subcode Paper type
0 Plain paper
1 Thick paper
2 Recycled paper
3 Thick paper 1
4 Thick paper 2
5 Thick paper 3*
6 Thick paper 4*
7 Special paper 1
8 Special paper 2
9 Special paper 3*
10 Thin paper*
11 Envelope
Transparency
12
(OHP film)
* e-STUDIO2515AC/3015AC/3515AC/4515AC/5015AC only
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
* This adjustment will have an effect only on Auto or Color mode printing.
Mac
Subcode
[05]
e-STUDIO
Code
2010AC/
2510AC
0 to
05-8071
4/7/8/11/12
0 to
05-8070
4/7/8/11/12
0 to
05-8090
4/7/8/11/12
0 to
05-8089
4/7/8/11/12
3-24
e-STUDIO
Recom Acceptable
2515AC/
mended value
3015AC/
value range
3515AC/
4515AC/
5015AC
Set a
0 to 12
value
smaller
0 to 255
than
0 to 12
the
default.
Set a
0 to 12
value
smaller
0 to 255
than
0 to 12
the
default.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Default
128
128