Toshiba e-STUDIO2010AC Imaging Manual page 118

2.Copier-specific Adjustments
(1) Perform automatic calibration for each paper type to correct variations in image density.
• A privilege to perform automatic calibration is set to Administrator by default but this can be
changed to the User. For how to change the privilege, refer to the MFP Management Guide.
• Follow steps (a) through (j) to perform the automatic calibration.
(a) Select [08 SETTING MODE]. Change the value of the code [9059] to "1" so that automatic
calibration for each paper type will be enabled.
Value for 08-9059
0
1
(b) Press [User Functions -User-] on [Home] screen to enter the "User Functions" menu.
(c) Press [Admin].
(d) Enter an administrator password in 6 to 64 digits. Press [OK].
(e) Press [General].
(f) Press [Calibration].
(g) Press [Copy].
(h) Select the paper type for correction.
(i) Press [Calibration] to print a test chart.
(j) Place the printed test chart on the original glass.
(k) Press the [START] button to start the calibration. The message "WAIT" disappears when the
calibration is finished.
• The procedure above covers both the color and black copy calibration.
After the automatic calibration, copy and check the image quality.
If further image quality adjustment is necessary, go to the next step.
(2) Select [05 ADJUSTMENT MODE]. Change the values for codes [7913] to adjust the amount of toner
used.
• The code to use varies according to the paper type. Adjust the value for [05] code corresponding
to the paper type for whose image quality you would like to improve and increase the value to
obtain the copy density that the user desires.
• In the [7913] setting, the toner amount of Y, M, C and K single colors is not changed, but that of
the overlaid colors reproduced by two or more colors, such as R, G, B and K, is controlled.
Paper type [05] code
Thick paper
Thick paper 1
Thick paper 2
Thick paper 3
Thick paper 4
05-7913
Special paper 1*
Special paper 2*
Special paper 3
Transparency
(OHP film)*
* Use the recommended Transparency (OHP film) and special paper 1 and 2.
© 2018 TOSHIBA TEC CORPORATION All rights reserved
Display for user calibration
Not displayed (default)
Displayed
Recommended
Subcode
value
1
3
4
5
6
128
7
8
9
12
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-64
Acceptable
Default
value range
0 to 255 128