Ricoh VT6000 Manual page 178

When one of the following messages is displayed on
the guidance display:
Guidance Display
RE-ENTER COPY NUMBER
MAXIMUM IS XXXX
RE-ENTER COPY NUMBER
MINIMUM IS XXXX
200% MAXIMUM
ENLARGEMENT
50% MINIMUM
REDUCTION
SET COMMAND SHEETS
SET THE ORIGINALS
The maximum number of prints
that can be entered is specified by
the Service
Change the number of prints.
The minimum number of prints that
can be entered is specified by the
Service Program mode. Change
the number of prints.
The maximum enlargement ratio
that can be entered is 200%. If the
entered reproduction ratio is over
200%, 200% will be selected.
The minimum reduction ratio that
can be entered is 50%. If the en-
tered reduction ratio is under 50%,
50% will be selected.
Make prints after
whether there is an original or a
command sheet on the exposure
glass.
TROUBLESHOOTING
Program mode.
you confirm
169