Ricoh VT6000 Manual page 243

PREPARING IMAGE MAKE-UP
When using the closed area method
The line designating the area must be a closed loop.
.
1
Put the command sheet on top of
the original.
.
2
Using a black, red, or blue felt tip
pen, draw a line around the area
to designate. The line should
have a thickness of at least 2
mm, 0.08". Make sure there is no
break in the line.
OK
Draw the line at least 2 mm,
0.08", from the image so that the
complete image can be recog-
nized.
10
NG = No good
Image within the
designated area
Line marking the
area
designated