Figure 162 Network > Interface > Cellular; Table 62 Network > Interface > Cellular - ZyXEL Communications 200 Series User Manual

Install (or connect) a compatible 3G card to use a cellular connection. See
Chapter 50 on page 749
The WAN IP addresses of a ZyWALL with multiple WAN interfaces must be on
different subnets.
Figure 162 Network > Interface > Cellular
The following table describes the labels in this screen.
Table 62 Network > Interface > Cellular
LABEL
#
Name
Extension Slot
Connected
Device
ISP Settings
Add icon
Apply
Reset
ZyWALL USG 100/200 Series User's Guide
for details.
DESCRIPTION
This field is a sequential value, and it is not associated with any interface.
This field displays the name of the interface.
This field displays where the entry's cellular card is located.
This field displays the name of the cellular card.
This field displays the profile of ISP settings that this cellular interface is set to use.
This column lets you create, edit, remove, activate, and deactivate cellular
interfaces.
To create an interface, click the Add icon at the top of the column. In the pop-up
window that displays, select the slot that you want to configure.
To activate or deactivate an interface, click the Active icon next to it. Make sure
you click Apply to save and apply the change.
To edit an interface, click the Edit icon next to it. The edit screen appears.
To remove an interface, click the Remove icon next to it. The ZyWALL confirms
you want to remove it before doing so.
To connect or disconnect an interface, click the Connect icon next to it. You might
use this icon to test the interface or to manually establish the connection.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 10 Interface
227