ZyXEL Communications 200 Series User Manual page 806

Appendix A Log Descriptions
Table 301 Interface Logs (continued)
LOG MESSAGE
AUX Interface
disconnecting failed.
This AUX interface is
not enabled.
Please type phone
number of interface
AUX first then dial
again.
Please type phone
number of Interface
AUX first then
disconnect again.
Interface %s will
reapply because Device
HA become active
status.
Interface %s will
reapply because Device
HA is not running.
Interface %s will stop
connect because Device
HA become standby
status.
Create interface %s
has been failed.
Base interface %s is
disabled. Interface %s
is disabled now.
Interface %s has been
changed.
Interface %s has been
added.
Interface %s is
enabled.
Interface %s is
disabled.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
806
DESCRIPTION
The AUX interface is not enabled and a user tried to use the
disconnect aux command.
A user tried to dial the AUX interface, but the AUX interface does not
have a phone number set.
The AUX interface does not have a phone number set and a user tried
to use the disconnect aux command.
Device-ha became active and is using a PPP base interface, the PPP
interface must reapply, %s is the interface name.
Device-ha was deleted and free PPP base interface, PPP interface
must reapply, %s is the interface name.
When device-ha is stand-by and use PPP base interface, PPP
interface connection will stop, %s: interface name.
When PPP can't running fail, %s: interface name.
When user disable ethernet, vlan or bridge interface and this interface
is base interface of PPP or virtual interface. PPP and virtual will disable
too. 1st %s is interface name, 2nd %s is interface.
An administrator changed an interface's configuration. %s: interface
name.
An administrator added a new interface. %s: interface name.
An administrator enabled an interface. %s: interface name.
An administrator disabled an interface. %s: interface name.
An administrator configured a PPP interface, PPP interface MTU >
(base interface MTU - 8), PPP interface may not run correctly because
PPP packets will be fragmented by base interface and the peer will not
receive correct PPP packets. 1st %s: PPP interface name, 2nd %s:
ethernet interface name.
An administrator configured ethernet, vlan or bridge and this interface
is base interface of PPP interface. PPP interface MTU > (base
interface MTU - 8), PPP interface may not run correctly because PPP
packets will be fragmented by base interface and peer will not receive
correct PPP packets.1st %s: Ethernet interface name, 2nd %s: PPP
interface name.
ZyWALL USG 100/200 Series User's Guide